Filter
Top Products
77
Chapter 7 Other Functions
Chapter 7
These settings are made when parameters are to be controlled with
the GK-3B VOLUME knob or DOWN/S1, UP/S2 switches, the VB-
99’s CONTROL buttons, an external pedal or other connected
controller, or a connected MIDI device.
In addition to settings already assigned to controllers, the VB-99 also
features sixteen prepared general-purpose control assigns that let
you freely assign settings to controllers as you like.
* If you intend to control the parameters of effects and the like, be sure to
set the effect to ON beforehand.
* For more detailed information on the parameters, refer to
“CONTROL ASSIGN”
(p. 135),
* Enabling the settings requires setting each of the controller
assignments to ASSIGNABLE in the SYSTEM CONTROL ASSIGN
screen. For detailed information, refer to
“Setting the GK VOLUME
Control and Switch and the Pedal Function (SYSTEM
CONTROL ASSIGN)”
(p. 42).
1.
Press [CONTROL ASSIGN]
2.
Select the controller you want to set with
PAGE [ ] [ ] and [F1]–[F6].
The various controllers’ setting screens appear.
* The following section describes the controllers you can set.
Using the Switches, Pedals,
and MIDI to Control the
Sounds (CONTROL ASSIGN)
Displayed
screen
Controller
GK VOL
GK VOL
Settings for the volume knob on the
GK-3B.
S1, S2
GK S1, S2
Settings for the switches on the
GK-3B.
CTL1
CONTROL1
Settings for the CONTROL 1 but-
ton on the VB-99’s top panel.
CTL2
CONTROL2
Settings for the CONTROL 2 but-
ton on the VB-99’s top panel.
Displayed
screen
Controller
PITCH
D BEAM T-ARM/
D BEAM FREEZE
Control of TREMOLO ARM/
FREEZE with the D Beam control-
ler
FILTER
D BEAM FILTER
Control of FILTER with the D
Beam controller
DBM V
D BEAM V
D Beam controller vertical sensor
DBM H
D BEAM H
D Beam controller horizontal sen-
sor
Displayed
screen
Controller
PITCH
RIBBON T-ARM
Control of PITCH with the TREM-
OLO ARM.
FILTER
RIBBON FILTER
Control of FILTER with the Ribbon
controller
RB POS
RIBBON POS
Ribbon controller position sensor
RB ACT
RIBBON ACT
Ribbon controller touch sensor
Displayed
screen
Controller
EXP
EXP PEDAL
Settings for the expression pedal
connected to the EXP PEDAL jack
on the VB-99’s rear panel.
CTL3
CTL3
Settings for the footswitch connect-
ed to the CTL3 jack on the VB-99’s
rear panel.
CTL4
CTL4
Settings for the footswitch connect-
ed to the CTL4 jack on the VB-99’s
rear panel.
VB-99_e.book 77 ページ ２００８年８月１８日 月曜日 午後１時１０分