Roland VB-99 Music Mixer User Manual


 
33
Chapter 2 Creating Sounds
Chapter 2
You can set the overall patch volume level with the V-BASS LEVEL
knob. Soon after the knob is turned, the V-Bass settings value pops
up in the screen.
* You can also adjust this parameter in Page 2 of the Mixer screen.
fig.01-060d
You can make separate settings in each individual patch for the
overall tone after sounds have passed through the mixer.
1.
Press [MIXER].
2.
Press PAGE [ ] [ ] to display Page 3 or 4.
3.
Switch the EQ on or off with [F1] (ON/OFF) on
Page 3.
4.
Set the tonal quality with [F1]–[F6] or with the
F1–F6 knobs.
5.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If not saving the settings, press [EXIT] to return to the Play screen.
For detailed information on all the parameters, refer to
“TOTAL EQ (Total Equalizer)”
(p. 131).
This sets the signals and levels output for each of the VB-99’s output
jacks and connectors.
1.
Press [MIXER].
2.
Press PAGE [ ] to display Page 5.
3.
Set the signal and level output to MAIN OUT
and SUB OUT with [F2]–[F5] or with the F2–F5
knobs.
For detailed information on the parameters that can be
set, refer to
“OUTPUT”
(p. 132).
4.
Press PAGE [ ] to display Page 6.
5.
Set the signal and level output to DIGITAL OUT
with [F2], [F3] or with the F2, F3 knobs.
6.
If you want to save the edited settings,
perform the Write procedure (p. 34).
* If not saving the settings, press [EXIT] to return to the Play screen.
Setting the Overall Patch
Volume Level (V-BASS LEVEL)
Adjusting the Overall Patch Tone
(TOTAL EQ)
Setting the Output Signal and
Level (OUTPUT)
You can also set the output signal and level for the
entire system.
1. Press [SYSTEM].
2. Press PAGE [ ] [ ] to display Page 2.
3. Press [F1] (OUTPUT).
4. Set the OUTPUT MODE parameter to
SYSTEM with [F1] (SELECT) or the F1
knob.
The value in the MIXER screen is disregarded, and
instead the SYSTEM value < > is applied.
VB-99_e.book 33 ページ 2008年8月18日 月曜日 午後1時10分