Filter
Top Products
167
Chapter 9 Appendices
Chapter 9
Unable to save SYSTEM/USB USB
IN settings
→
If the USB IN parameter is set to COSM BASS A, COSM
BASS B, or NORMAL PU, then MAIN & SUB will be set
the next time the VB-99 is powered up. If you plan to use
COSM BASS A, COSM BASS B, or NORMAL PU,
remake this setting each time you turn on the power to
the VB-99 (p. 152).
Patches not switching
❏
Is some screen other than the Play screen shown in the
display?
→
With the VB-99, you cannot switch patches in any screen
other than the Play screen. Press [EXIT] one or more
times to return to the Play screen (p. 20).
❏
Is [SYSTEM] - MISC - PATCH EXTENT set correctly?
→
The range of patches that can be selected is limited by
the PATCH EXTENT setting. Be sure to set this correctly.
Unable to control parameters set
with Assign as expected
❏
Are the effects switched off?
→
Check to make sure the effects incorporating the
parameters being controlled are on.
❏
Is the patch set to anything other than ASSIGNABLE
(PATCH) in [SYSTEM] - CONTROL ASSIGN?
→
Even with the patch’s [CONTROL ASSIGN] setting
made, the settings made in [SYSTEM] - CONTROL
ASSIGN are given priority.
To enable the settings in the patch, set the controllers
under [SYSTEM] - CONTROL ASSIGN to ASSIGNABLE
(PATCH).
❏
Are the MIDI channels matched?
→
When carrying out operations using MIDI, check to
confirm that both devices are set to the same MIDI
channel (p. 52).
❏
Are the controller numbers (CC#) matched?
→
Check to confirm that the controller numbers you are
using are the same (p. 56).
MIDI messages not being
transmitted/received
❏
Could there be a short in the MIDI cable?
→
Try replacing the MIDI cable.
❏
Are the VB-99 and the external MIDI device connected
properly?
→
Check the connection with the external MIDI device.
❏
Are the MIDI channels matched?
→
Check to confirm that both devices are set to the same
MIDI channel (p. 52).
❏
Are the Device ID matched?
→
Check to confirm that both devices are set to the same
Device ID (p. 53).
❏
If you are transmitting from the VB-99, have the
settings for transmission been made?
→
Check the Program Change message transmission ON/
OFF setting (p. 54) and the settings for the controller
number to be transmitted (p. 56).
Parameters Indicated with Angle
Brackets
→
When a parameter appears in angle brackets (< >), it
indicates the parameter is currently disabled.
System parameters take priority over the patch
parameters shown below; depending on the settings,
these patch parameters may be disabled.
Please confirm the settings for the corresponding system
parameters.
Other Problems
Disabled Patch
Parameters
Corresponding System
Parameters
[CONTROL ASSIGN]
(p. 77)
[SYSTEM] - CONTROL ASSIGN
(p. 42)
[MIXER] - OUTPUT
(p. 33)
[SYSTEM] - OUTPUT - OUTPUT
MODE (p. 45)
[NAME/KEY/BPM] - TX
PC (p. 54)
[SYSTEM] - MIDI - TX PC MAP
(p. 55)
[NAME/KEY/BPM] -
BPM (p. 142)
[SYSTEM] - BPM - SYSTEM BPM
(p. 153)
VB-99_e.book 167 ページ ２００８年８月１８日 月曜日 午後１時１０分