Startup & shutdown
12 TASCAM DP-01 Owner’s Manual
Starting out with your DP-01
Shutting down the DP-01
If you don’t shut
down the DP-01 in
the way described here, you may
lose your recordings and settings.
Always shut down the DP-01
according to these instructions.
1 First, stop playback or recording.
2 Press and hold the SHUT DOWN key for about a second. The screen
shows:
3 Press ENTER to start the shut down process.
Pressing the
EXIT
key cancels the
shutdown process.
The display shows: Storing Song...
4 Once the song data is stored to hard disk, the display shows:
5 You can now use the rear panel switch to turn off the DP-01.
The ACCESS light
Do not move the
DP-01 or turn it off
or disconnect the power when the
ACCESS
indicator is lit, to avoid
damage to the hard disk and possi-
ble loss of data.
This red indicator shows that the hard disk or the CD-RW drive is in
use. Although the DP-01 is not exactly a delicate piece of equip-
ment, you should take care with it, as with all electronic equipment,
especially when the hard disk is in operation or when it is writing to
CDs.
How to play back demo songs
Before the DP01 is shipped, demo songs are stored on its hard disk. Fol
low the procedure below to play back these demo songs.
1 Connect the LINE OUT connector on the DP-01 to the amplifier or
monitor system. To listen on headphones, insert the headphone plug
into the PHONES jack on the right of the front panel.
2 Switch on the DP-01.
When the DP-01 is started up, the display shows the home screen.
Figure 1.2: SHUT DOWN and ACCESS
DP-01_OM_E.book 12 ページ 2005年6月13日 月曜日 午後7時14分