Filter
Top Products
Starting out with your DP-01
TASCAM DP-01 Owner’s Manual 23
Assigning inputs
Assigning inputs
When we talk about “assigning” inputs, we are talking about routing
the signals from the two inputs to the tracks.
You can record on up to two tracks at a time. This means that the
same input can be assigned to two tracks at the same time (but you
can’t then use the other input) or the two inputs can be assigned to
different tracks. You can’t assign both inputs to the same track at the
same time.
Press and hold the ASSIGN key corresponding to the input signal you
are assigning (
A or B).
Press and hold
SHIFT
and either of
the
ASSIGN
keys (
A
or
B
) to turn
the inputs on or off as shown by the
indicator. You may want to turn off
unused inputs to reduce noise.
While holding down the ASSIGN key, press the REC key of the track to
which you are assigning the input.
The
REC key flashes rapidly.
If you want to assign the input to another track, you must first clear
the current assignment (see below), and then re-assign the input.
Note that the
REC key of the first track to which you assigned the
input flashes when you hold down the
ASSIGN key.
Clearing an assignment Hold down the ASSIGN key to check current
assignments, then while holding the
ASSIGN key, clear current assign-
ments by pressing a flashing
REC key (which then stops flashing).
Figure 1.7: Assigning inputs to tracks
Press and hold
one of the
ASSIGN keys
And then press
one of the 8
REC keys
DP-01_OM_E.book 23 ページ ２００５年６月１３日 月曜日 午後７時１４分