Filter
Top Products
Starting out with your DP-01
TASCAM DP-01 Owner’s Manual 17
Connecting your DP-01 to other equipment
The DP-01FX and
DP-01FX/CD
include phantom-powered XLR
microphone input connectors. See
“DP-01FX Appendix” on page 62
for details of using these connec-
tors.
Microphones are connected to the front panel inputs.
Set the
GUITAR/LINE switches to LINE. Turn the input level controls so that
the
OL indicators light up only in the loudest part of the recording.
Synthesizers, etc. including drum machines, guitar amplifier simula
tors, active basses, etc. as well as CD players, cassette decks, and so on can
be connected to the front panel input jacks using standard 1/4" mono plugs
(unbalanced). When you are recording a stereo source, make sure the
INPUT MODE switch is set to STEREO (see “The INPUT MODE switch”
on page 18).
NEVER plug the
speaker outputs of
a guitar amplifier into the DP-01.
Set the GUITAR/LINE switch to LINE. Adjust the input level controls and use
the instrument’s output volume controls to adjust the level so that the
OL
indicators light up only during the very loudest passages.
Guitars and basses (passive types) are connected to the front panel
input
A using a standard 1/4" mono plug (unbalanced).
Use the built-in
tuner (on the DP-
01FX and DP-01FX/CD) to tune the
guitar or bass (see “Tuning a guitar”
on page 62).
Set the GUITAR/LINE switch to GUITAR. Turn the input level control until the
OL indicators barely light on the loudest passages.
Headphones Plug a pair of standard headphones into the 1/4" stereo
jack on the front panel.
Adjust the volume with the level control to the right of the jack.
The footswitch is
useful if both hands
are busy playing a guitar, for exam-
ple.
Footswitch You can connect a standard “punchin” footswitch, such as
the TASCAM RC30P to the front panel
PUNCH jack.
Use the switch to punch in and out (that is, start and stop recording on the
fly).
Figure 1.5: DP-01FX front panel
Microphones go here
(DP-01FX, DP-01FX/CD)
Guitars, basses
etc. go here
Synths, pre-amps etc. (&
microphones on DP-01)
go here
Input level
controls
To headphones (and
level)
To
footswitch
Turn on ONLY for
condenser microphones
(DP-01FX, DP-01FX/CD)
Select monitoring
mode (see text)
DP-01_OM_E.book 17 ページ ２００５年６月１３日 月曜日 午後７時１４分