Filter
Top Products
62 TASCAM DP-01 Owner’s Manual
DP-01FX Appendix
3 : DP-01FX Appendix
The DP-01FX differs from the DP-01 in a few important respects: it
provides balanced XLR connectors with switchable phantom power
for connecting condenser microphones, there is a built-in guitar/bass
tuner, it provides a multi-processor for the input signals, and noise
reduction, and it provides a reverb effect for the mixdown process.
Balanced XLR inputs
These XLR inputs
are wired with
these pin assignments: 1=ground,
2=hot, 3=cold.
These inputs enable you to connect condenser microphones (the
same type as those used in professional recording studios).
The +48V phantom power supply allows you to power condenser micro
phones. Without such phantom power, many condenser microphones will
not work. Some, however, use internal batteries.
Never connect or
disconnect micro-
phones to or from the XLR connec-
tors with the phantom power turned
on.
Never turn the phantom power on
when unbalanced dynamic micro-
phones are plugged into the XLR
connectors.
Consult any documentation that came with your microphones for full
details of power requirements, etc.
Phantom power
The PHANTOM switch can be turned ON or OFF to supply +48V phantom
power to the XLR connectors. Phantom power is not supplied to the 1/4"
jacks.
Input level controls
Use the input level controls the same way you would microphones that use
1/4" jacks.
However, some microphones are more powerful than others, and you may
need to turn down the control to prevent overloading.
Tuning a guitar
The built-in tuner allows you to tune a guitar or bass connected to
input
A only.
Press the MULTI key and the REVERB key together:
Play a single string. The DP-01FX makes its “best guess” at the note,
shows the value, and provides an indication of whether it’s sharp or
flat. This is a very flat F#:
DP-01_OM_E.book 62 ページ ２００５年６月１３日 月曜日 午後７時１４分