Filter
Top Products
25
Voice Effects
One-touch Preset Recall
Press the PRESET LCD button to instantly recall the preset effect
type and DEPTH1(R) settings for the current voice. The DEPTH2(L)
setting is not affected.
• Each voice has its own individual
default effect on/off, type, and depth
settings. Your own settings can be
backed up via the Backup function
described on page 107.
• The DEPTH2(L) setting affects all
voices. Its default value is “50”, but
your own setting can be backed up via
the Backup function described on page
107.
COMPRESSOR Affects the dynamics of the sound by
smoothing out the high-volume
peaks and soft-volume dips.
BOOST HL Equalizer to boost high and low
frequencies.
PHASER Pronounced, metallic modulation with
periodic phase change.
AUTO WAH Repeating filter sweep “wah” effect.
TOUCH WAH Wah effect that varies filter sweep
according to touch.
(CVP-79A only)
(CVP-79A only)
Effect Depth Control
When a single voice is selected only one depth parameter will appear.
When the DUAL or SPLIT mode is engaged, separate depth parameters
will appear for the main and 2nd (dual) or right- and left-hand (split)
voices. The depth of the selected effect can be increased or decreased by
using the DEPTH1
(
R
)
and/or DEPTH2
(
L
)
LCD buttons, or the data dial
or [+]/[–] buttons when the DEPTH1
(
R
)
or DEPTH2
(
L
)
parameter is
highlighted. The DEPTH1
(
R
)
and DEPTH2
(
L
)
buttons can be held to
only increase the depth of the corresponding voice. The depth range is
from “0” (no effect) to “100” (maximum effect depth). The default
DEPTH1(R) or DEPTH2(L) setting can be instantly recalled for either
depth parameter by simultaneously pressing the [+] and [–] buttons while
the desired depth parameter is selected — DEPTH2(L) is reset to “50”.
– +
• The main or right-hand voice effect
type is commonly used for the 2nd or
left-hand voice.
• The depth can be adjusted in five step
intervals.
• The DEPTH1(R) and/or DEPTH2(L)
value for some effect types may be
fixed to 100 and/or 0 respectively and
cannot be changed.