Filter
Top Products
58
LS9-16/32 Owner’s Manual
8
To switch the phase of each channel
between normal and reverse phase, move
the cursor to the ø button of the desired
channel in the window, and press the
[ENTER] key.
The ø button will change from black to red, and the
phase of the corresponding channel will be reversed.
9
If you want to operate the HA of a channel
that is not currently shown in the popup
window, use the [SEL] key to select that
channel, and then make settings for it.
For example if INPUT channels 1–8 are shown in the
popup window, pressing the INPUT channel 9 [SEL]
key will change the popup window to INPUT channels
9–16.
10
When you’ve finished making settings,
move the cursor to the CLOSE button (or
the × symbol in the upper right of the win-
dow) and press the [ENTER] key.
Here we will explain how to send the signal of an input channel to the STEREO bus or MONO
bus.
The STEREO bus / MONO bus are used to output signals to the main speakers. Signals can be
sent to the STEREO bus or MONO bus in either ST/MONO mode or LCR mode, and you can
choose either of these two modes for each channel. These two modes differ as follows.
■ ST/MONO mode • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In this mode, signals are sent independently from the input channel to the STEREO bus and to the MONO bus.
• The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/
off independently.
• The panning of the signal sent from an INPUT channel to the STEREO bus L/R can be operated by the
SELECTED CHANNEL section [PAN] encoder, or by the TO ST PAN knob in the screen. (The signal sent to
the MONO bus is not affected by this encoder or knob.)
• The volume balance of the signal sent from a ST IN channel to the STEREO bus left and right can be operated
by the SELECTED CHANNEL section [PAN] encoder, or by the TO ST BALANCE knob in the screen. (The
signal sent to the MONO bus is not affected by this knob.)
■ LCR mode • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In this mode, the signal from the input channel is sent to three buses at once; STEREO (L/R) and MONO (C).
• The signals sent from the same input channel to the STEREO bus and to the MONO bus can be switched on/
off together.
• The CSR (Center Side Ratio) knob in the screen adjusts the proportion of the signal level sent from the input
channel to the STEREO (L/R) bus and the level sent to the MONO (C) bus.
• The level of the signal sent from the input channel to the STEREO (L/R) bus and the MONO (C) bus will
change according to the settings of the SELECTED CHANNEL section [PAN] encoder or the TO ST PAN
knob / TO ST BALANCE knob in the screen.
Sending the signal from an input channel to the STEREO/MONO bus
• If you want to use headphones etc. to monitor the signal of the STEREO bus or MONO bus, you should
press the DISPLAY ACCESS section [MONITOR] key several times to access the MONITOR screen, and
select “LCR” as the monitor source (
→
p. 146).
HINT
HA (head amp) settings • Sending the signal from an input channel to the STEREO/MONO bus