Filter
Top Products
The value can be set in 1 second steps.
The auto sampling time can also be specified in BPM units. To do
this, hold down the [BPM] key and use the [-] and [+] keys to
change the time. The display will change to BPM units. The time
corresponding to four beats of the displayed BPM value will be the
auto sampling time. Pressing the [BPM] key again returns to the
normal display.
•When auto recording mode is selected
Sampling starts as soon as the signal exceeds the preset trigger
level for the first time. Pressing the [PLAY/STOP] key stops
sampling.
When auto recording mode is used to sample a source with a slow
attack curve, the beginning of an attack sound may be cut off.
•When auto stop mode is selected
Sampling starts according to the conditions set for auto recording
mode, and ends when the preset auto sampling time has elapsed.
Auto recording mode and auto stop mode can be used together.
By following steps 8 - 11 shown on page 22, you can assign the
sample to a pad.
HINTHINT
NOTE
HINTHINT
While holding down the [PLAY/STOP] key, use the [-] and [+] keys to change the auto stop
sampling time
5
STEP
Press the [RECORD] key to start sampling.
6
STEP
Use the [PLAY/STOP] key to check the recorded sample.
7
STEP
24
Let's Try Out Sampling
Level
Time
Trigger Level
Sample
Sampling start Sampling end
PLAY/STOP
RECORD
Auto recording mode sampling
Level
Time
Auto Sampling Time
Sample
RECORD
Sampling start Sampling end
Auto stop sampling
RECORD
PLAY/STOP
PLAY/STOP
+–
[–] [+] keys