Filter
Top Products
28
Pad Play Mode Operation
The number of the currently selected sample appears on the display.
The indication "SCALE" appears on the display.
The sample selected in step 1 is assigned to all pads 1 - 8, and the
pad tuning is automatically changed using a Major scale, using pad 1
as the prime. For example, if the original pitch was middle C, the
tuning for the various pads, depending on the pad chosen in step 5,
will be as follows.
If the selected bank already contains
pads with samples, these will be
erased.
• When wishing to cancel the
automatic assignment process,
press the [EXIT] key.
• When wishing to use a different
scale, edit the TUNING parameter
for each pad in step 6 (
➔
p. 32).
NOTE
HINTHINT
Sometimes it may be useful to assign the same sample to several pads and play the pads with changed
pitch (such as when a single bass note was sampled). The ST-224 can automatically assign one sample to
pads 1 - 8 and change the pad tuning using a Major scale.
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN
CAPACITY
ERASE OPTIMIZE
PLAY/STOP
RECORD
EDIT 2
HIGH-PASS
LOW- PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GATE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT
3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+
–
AUTO SYNC
PLAYLIST
TAP
BPM
MEASURE
SAMPLE/SONGBEAT
+
–
[–] [+] keys
+
PAD ASSIGN
SPECIAL
PAD ASSIGN
PAD ASSIGN
BPM/
VALUE
MEASURE
SAMPLE/SONGBEAT
While holding down the [SPECIAL] key, press the [PAD ASSIGN] key.
1
STEP
To activate the automatic assignment process, press the [PAD ASSIGN] key again.
6
STEP
Use the [-] and [+] keys to select the sample number.
2
STEP
Use the [BANK 1] - [BANK 3] keys to select the bank to which you want to assign the sample.
4
STEP
Press the [PAD ASSIGN] key again.
3
STEP
Use pads 1 - 8 to select the pad to which the sample should be assigned with the original pitch.
5
STEP
Assigning a Sample to a Major Scale
Pad 1
= Original pitch
Pad 2 Pad 3 Pad 4 Pad 5 Pad 6 Pad 7 Pad 8
Pad 1 was
pressed
Pad 2 was
pressed
Pad 3 was
pressed
BPM/
VALUE
MEASURE
SAMPLE/SONGBEAT