Filter
Top Products
59
Storing and Reading Data
This section explains how to save the entire main memory contents or the waveform data for a pad to the
backup memory and how to load this data back into the main memory.
Storing and Reading Data
Bulk data (all waveform data, pad parameter settings, song data for
internal sequencer) are saved to the backup memory. The ST-224
then returns to the regular play mode. When wishing to cancel the
store process, press the [EXIT] key instead of the [SAVE] key.
• The backup memory can hold only one set of bulk data.
The previous set will be overwritten.
• During storing, all currently playing pads are stopped
(including the [SOURCE] pad).
Bulk data are copied from the backup memory into the main memory.
The ST-224 then returns to the regular play mode. When wishing to
cancel the load process, press the [EXIT] key instead of the [LOAD] key.
When the unit is turned on, the last bulk data saved in backup
memory are copied back to the main memory.
HINTHINT
NOTE
This section explains how to save bulk data (main memory contents) to the backup memory and how to
load bulk data from backup memory into the main memory.
SONG
PAD
FUNCTION
PAD ASSIGN
CAPACITY
ERASE OPTIMIZE
ON/OFF
PAD ENABLE
B
EFFECT SYNC
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
AUTO SYNC
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
To save bulk data, press the [SAVE] key.
1
STEP
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
Press the [SAVE] key again.
3
STEP
BACKUP
LOAD SAVE
INTERNAL/DATA CARD
To load data from backup memory into the main memory, press the [LOAD] key while the
unit is in play mode.
4
STEP
Use the [INTERNAL/DATA CARD] key to set the load target to "Int" (internal).
5
STEP
Press the [LOAD] key again.
6
STEP
Use the [INTERNAL/DATA CARD] key to set the save target to "Int" (internal backup
memory).
2
STEP
Storing/Reading Bulk Data (Backup Memory)
CAUTION
Never turn power to the unit off while
data are being saved. Otherwise the
data may be destroyed.