Filter
Top Products
The [SONG PLAY/STOP] LED lights up and playback of the song
starts at the beginning.
• Also during playback of a song, you can hit pads to play them
manually. However, the maximum number of simultaneous
sounds may not be exceeded.
• Effect operations are not recorded in the song.
• Pressing the [SONG PLAY/STOP] key while holding down the
[LOOP/MARK] pad causes the song to be repeated.
The [SONG PLAY/STOP] LED goes out.
The playback start position is indicated on the display, using the
number of bars.
The number of bars shown on the display changes according to the
[-] [+] key operation.
You can also use the [EDIT 1] wheel instead of the [-] [+] keys.
The new start point is set. Song recording and playback can be
carried out from this point.
HINTHINT
This section describes how to play a song that has been recorded.
PAD ASSIGN
CAPACITY
ERASE OPTIMIZE
PLAY/STOP
RECORD
RE-SAMPLE
GRADE
MONO
STEREO
SAMPLING
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW- PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
COPY DELETE
BACKUP
EXIT
SPECIAL
LOAD SAVE
INTERNAL/DATA CARD
+
–
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOPREC
BPM/
VALUE
MEASURE
SAMPLE/SONGBEAT
+–
[–] [+] keys
SONG
PLAY/STOPREC
SONG
PLAY/STOPREC
In play mode, use the [-] [+] keys to select the song number (1 - 8).
1
STEP
Press the [SONG PLAY/STOP] key.
2
STEP
To stop the song, press the [SONG PLAY/STOP] key again.
3
STEP
+
SONG
PLAY/STOPREC
SPECIAL
You can also change the playback position of the song. While the song is stopped, hold
down the [SPECIAL] key and the press the [SONG PLAY/STOP] key.
4
STEP
+–
[–] [+] keys
SONG
PLAY/STOPREC
Use the [-] [+] keys to specify the bar.
5
STEP
When you have specified the desired position, press the [SONG PLAY/STOP] key.
6
STEP
51
Creating Songs
Playing a Song
HINTHINT
Number of bars at playback start position
BPM/
VALUE
MEASURE
SAMPLE/SONGBEAT