The ST-224 has 22 types of built-in effects. You can select any effect and apply it to the sound of any pad. The
[EDIT 1] wheel and [EDIT 2] knob on the unit can be used to adjust effect parameters in real time. It is also
possible to synchronize a specific effect parameter with a certain BPM value.
Using the Internal Effects
42
Using the Internal Effects
Rotate the [EFFECT SELECT] switch so that it points to the desired
effect type. Use the [EFFECT BANK] key to switch between bank A
(effect types without underline) and bank B (effect types with
underline).
The LEDs of the selected pads light up, and the sound from these
pads will be processed by the effects section.
By pressing the [SOURCE] pad, the input source that is controlled
by the [SOURCE] pad (
➔
p. 26) can also be routed to the effects
section (excluding certain effect types).
The TIME STRETCH/SCRATCH effect can be applied only to
sampled sound.
While the [EFFECT ON/OFF] key is held down, the [EFFECT ON/OFF]
LED is lit and the effect is on.
This section explains how to select an effect type, apply an effect to a pad, and how to adjust effect
parameters.
Hold down the [EFFECT PAD ENABLE] key and use the [BANK 1] - [BANK 3] keys and the
pads 1 - 8 to select the pad to which to apply the effect. (Multiple pads can be selected.)
