A SERVICE OF

logo

Open as PDF
next previous
SET MODULE PHY_SELECTION
2-159
SET MODULE
PHY_SELECTION
Use the SET MODULE PHY_SELECTION command to specify the preferred PHY
when two PHYs are installed and are operational.
A PHY is a physical port. Dual ports provide physical redundancy in the event a
physical link or ATM switch fails.
Format
Example
The following command selects PHY 2 as the preferred PHY:
CB5000> set module 4.1 phy_selection 2
Phy Configuration Select set to 2.
Warning: change does not take effect until module is reset.
Related Commands
SET MODULE PHY_AUTOMATIC_FAILOVER
SHOW MODULE
slot.
1
1 through 17. Indicates the slot number of the module you are configuring.
1
Selects PHY 1.
2
Selects PHY 2.
set module phy_selection
1
2
slot.
1