Filter
Top Products
23
Names and Functions
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
?
SURE
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
Warning messages
The following warnings are shown operating mistakes are
made, an unsuitable editing point (= locate point) is input,
or when errors occur. If any of these warnings appear,
refer to information detailed below.
<Void Data> message
This means registered data necessary for the selected operation
is incorrect.
Action to take:
Re-register the correct data.
<Void Out> message
This means the registered in/out point is wrong.
Action to take:
Re-register the correct data.
<Track unselected> message
This means a track has not been specified.
Action to take:
Select any one track with the RECORD TRACK select key.
<Over> message
This means that disk space necessary for recording and editing
is insufficient.
Action to take:
Before proceeding to the next operation, temporarily data in
order to source empty space necessary for the next operation.
<Load Err > message
This means that loading is impossible because there is an error
in data applied to the DATA IN connector from the external
DAT.
Action to take:
Check the external DAT connected to the DATA IN connector
and be sure there is no problem with the DAT tape. Then, try
loading again.
<Unformat !> message
An unformatted or crashed SCSI disk.
After a few seconds of this display, the FD-4 automatically enters
the SETUP mode [Format ?] menu.
Action to take:
Press the EXECUTE/YES key while pressing the RECORD button.
<Track Over> message
This means the number of recording tracks has been exceeded.
Action to take:
Simultaneous recording is possible on only two tracks. Setup
the recording track again.
<Can’t Rec> message
This means the specified additional track cannot be recorded.
This is displayed when recording is attempted on the additional
track by using the [Mastering mode 2] disk.
Action to take:
If recording is to be make on the additional track, format in the
[Normal mode] or [Mastering mode 1].
<Protected> message
This means the disk inserted in the drive cannot be used because
it is write-protected. The disk will be ejected automatically.
Action to take:
Release the write-protect and re-insert it.
<Rec + Yes !> message
This means press the EXECUTE/YES key while pressing the
RECORD button (This is displayed when formatting).
Action to take:
Press the EXECUTE/YES key while pressing the RECORD button.
<Note>
Any sound data recorded up to this point on the disk will be lost.