Filter
Top Products
Editing Tracks
61
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK
SCSI
Executing Track Exchange
1. While the FD-4 is stopped, press the EDIT key repeatedly
until [TRK Exchg] flashes on the display.
Alternatively, you can press the EDIT key, then use the
JOG dial.
2. Press the EXECUTE/YES key.
The display shows the track selection.
The current display shows that you can swap two-track
data between Additional tracks L/R and rear tracks 1–2.
If you wish to select other tracks, follow the steps below.
3. Select the tracks to swap data.
• Selecting Additional tracks L–R and Real tracks 3–4:
1. Press the HOLD/> key, the REWIND button, or the F FWD
button to move a flashing cursor on [L–R] (left) to
[1–2](right).
2. Turn the JOG dial to change flashing [1–2] to flashing
[3–4].
• Swapping mono track data
1. When [L–R] is flashing, turn the JOG dial.
Turning the JOG dial allows you to select a mono track
from [1], [2], [3], [4], [L], and [R] in the left column.
The right column continues to indicate [1].
For example, if you select [4] in the left column, the
display indicates [4<>1], meaning you can swap data
between tracks 4 and 1.
2. To select a number in the right column, press the
HOLD/> key, the REWIND button, or the F FWD button
to move the flashing cursor to the right column, then
use the JOG dial to select the desired number.
* When you swap data between mono tracks, the indications [4<>1]
and [1<>4], for example, mean the same thing — swapping data
between tracks 1 and 4.
<Note>
If you select the same tracks for swapping mono track data, the
setting is ignored. The FD-4 will indicate [Select Err] for a short mo-
ment, then return to the previous display.
4. Press the EXECUTE/YES key.
[Exchange] lights up and the swapping operation is
completed immediately.
The FD-4 indicates [COMPLETED !], then returns to the
previous Time Base display.
* You cannot play data or check the REC END point on the
Additional tracks. To do so, you need to move the data to a
Real track.
If you load back-up data from an external DAT recorder, the
data maintains the same condition as when you previously
saved it to DAT.