Filter
Top Products
p. 34
stereo matrix / aux out module
stereo-matrix features
mtx to aux
When this switch is depressed, a post stereo matrix level signal is fed to
the modules left and right Aux (Monitor) mix buses. An internal jumper
allows the matrix to be sourced pre fader if desired. This allows generic
mixes such as drums to be able to be mixed with the primary aux moni-
tor outputs.
insert-on switch
Activates the stereo Insert return connector. Signal is always fed to the
stereo balanced insert send connector.
peak and signal-present LED
A single dual color LED monitors pre level control stereo signal levels.
Dynamic level indications are by varying the intensity of the green element
of the dual color LED.The LED will turn RED if signal approaches 3dB of
causing clipping of the left or right outputs.
stereo matrix solo-switch
Will illuminate when manually selected in one of the consoles many Solo
modes. Controls within the master section determines if this switch will
sample signal pre or post level control.
Additional switches will determine the operating characteristics of the
Solo system. These may be selected from within the master section to be
NORMAL (cumulative), LAST PRESSED (Only one switch will be on at a
time.Selecting the next solo switch will automatically cancel the last switch
selected) or MOMENTARY (Solo system on only while switch is held
down).
talkback preset-switch
When selected will allow the Master Talkback Switch and system to access
the associated Stereo output matrix.
stereo matrix output-level control
Adjust the left and right output levels of this section.
stereo matrix output-balance control
Adjusts the balance between the left and right outputs.
write-on strip
Will provide a number for this group output as well as providing a write
in area for the customer or a mounting surface for the customers mask-
ing tape labeling.