Filter
Top Products
stereo matrix / aux out module
dual-aux output features
This section controls aux outputs number 9 through 16. It is intended to
operate as individual aux outputs, or when the module’s stereo mode
switch is depressed, as a stereo output. In stereo configuration, this out-
put par may be used to generate dedicated broadcast or cart machine
feeds, or when used as a monitor console, to generate stereo wedge or
“In the Ear” monitor feeds.
XLR-input odd-level control with push-on/push-off switch
Controls the contents of the associated left XLR aux bus input level into
the associated (odd numbered) mix bus. This may be used to return
effects returns into the aux system when used for “In the Ear” type mon-
itoring systems, or simply to expand the number of inputs available.
Pushing this control will turn the input source on and off and is indicated
by a status LED indicator located next to the control.
XLR-input even-level control with push-on/push-off switch
Controls the contents of the associated right XLR aux bus input level into
the associated (odd numbered) mix bus. This may be used to return
effects returns into the aux system when used for “In the Ear” type mon-
itoring systems, or simply to expand the number of inputs available.
Pushing this control will turn the input source on and off and is indicated
by a status LED indicator located next to the control.
solo-left and solo-right
Will individually, or when both are depressed as a stereo pair, monitor the
contents of the XLR INPUT returns.
global-input stereo switch
Reconfigures the associated input modules dual concentric aux controls
from dual mono mode to a level and pan pot configuration to enable sim-
ple construction of stereo mixes.
polarity-reverse switch
(one odd channel, one even channel)
Reverses the polarity of the aux output signals.
insert-on switch
(one odd channel, one even channel)
Activates Insert return connector. Signal is always fed to balanced insert
send connector.
peak and signal-present LED
(one odd channel, one even channel)
A single dual color LED monitors pre fader signal levels. Dynamic level
indications are by varying the intensity of the green element of the dual
color LED.The LED will turn RED if signal approaches 3dB of clipping of
the left or right outputs.
p. 35