Filter
Top Products
37
04: ISOLATOR
This is an equalizer that radically cuts the volume of selected frequencies,
allowing you to create special effects cutting the volume in various ranges.
fig.MFX04
05: LOW BOOST
Boosts the volume of the lower range, creating powerful lows.
fig.MFX05
Parameter Value Description
Boost/Cut High #3
-60– +4 dB
These boost and cut each of the High, Middle,
and Low frequency ranges.
At -60 dB, the sound becomes inaudible. 0 dB
is equivalent to the input level of the sound.
Boost/Cut Middle #2
Boost/Cut Low #1
AntiPhase Middle
Sw
OFF, ON
Settings of the Anti-Phase function for the Mid-
dle frequency ranges.
When turned on, a stereo copy of the sound is
phase-inverted and added to the signal.
AntiPhase Middle
Level
0–127
Adjusts the level settings for the Middle fre-
quency ranges.
Adjusting this level for certain frequencies al-
lows you to lend emphasis to specific elements
within a sound. (This is effective only for stereo
source.)
Anti Phase Low Sw OFF, ON Settings of the Anti-Phase function for the Mid-
dle frequency ranges
The parameters are the same as for the Middle
frequency ranges.
Anti Phase Low
Level
0–127
Low Boost Sw OFF, ON
Turns Low Booster on/off.
This emphasizes the bottom frequencies to cre-
ate a heavy bass sound.
Low Boost Level 0–127
Increasing this value gives you a heavier low end.
* Depending on the Isolator and filter settings,
this effect may be hard to hear.
Level 0–127 Output level
L in
R in
L out
R out
Isolator
Low Boost
Low Boost
Isolator
Parameter
Value Description
Boost Frequency
#1
50–125 Hz
Center frequency at which the lower
range will be boosted
Boost Gain #2 0–12 dB
Amount by which the lower range will be
boosted
Boost Width #3
WIDE, MID, NAR-
ROW
Width of the lower range that will be
boosted
Low Gain -15– +15 dB Gain of the low frequency range
High Gain -15– +15 dB Gain of the high frequency range
Level 0–127 Output level
L in
R in
L out
R out
Low Boost
2-Band EQ
2-Band EQ
Low Boost
ARX-01_e.book 37 ページ ２００８年２月１９日 火曜日 午後４時７分