Filter
Top Products
8
Installing the expansion board in your product
Cautions when installing
• Before you install this expansion board (hereafter referred to as “the
board”), you should carefully read the procedure for installing
expansion boards given in the owner’s manual of the product in which
you’re installing it.
• To avoid the risk of damage to internal components that can be
caused by static electricity, please carefully observe the following
whenever you handle the board.
• Before you touch the board, always first grasp a metal object (such
as a water pipe), so you are sure that any static electricity you
might have been carrying has been discharged.
• When handling the board, grasp it only by its edges. Avoid
touching any of the electronic components or connectors.
• Save the bag in which the board was originally shipped, and put
the board back into it whenever you need to store or transport it.
• Do not touch any of the printed circuit pathways or connection
terminals.
• Never use excessive force when installing a circuit board. If it doesn’t
fit properly on the first attempt, remove the board and try again.
• When you’ve finished installing the expansion board, follow the steps
described in the owner’s manual of your device to verify that the
board was installed correctly.
1.
As described in your product’s owner’s manual, expose
the slot in which the expansion board is to be installed.
2.
Orient the board with the slot of your product as shown
in the illustration.
Installation in your product
Slot of the product
Board
(expansion board)
Non-latched holders
Latched holders
Roland logo
Holes that engage the
non-latched holders
ARX-01_e.book 8ページ ２００８年２月１９日 火曜日 午後４時７分