Filter
Top Products
49
25: GUITAR AMP SIM (Guitar Amp Simulator)
This is an effect that simulates the sound of a guitar amplifier.
fig.MFX25
Parameter Value Description
Pre Amp Sw OFF, ON Turns the amp switch on/off.
Pre Amp Type #1
JC-120,
Clean Twin,
Match Drive,
BG Lead,
MS1959I,
MS1959II,
MS1959I+II, SLDN
Lead, Metal 5150,
Metal Lead,
OD-1, OD-2 TURBO,
Distortion, Fuzz
Type of guitar amp
Pre Amp
Volume #2
0–127
Volume and amount of distortion of the
amp
Pre Amp
Master #3
0–127 Volume of the entire pre-amp
Pre Amp Gain Low, Mid, High Amount of pre-amp distortion
Pre Amp Bass
0–127
Tone of the bass/mid/treble frequency
range
* Middle cannot be set if “Match Drive”
is selected as the Pre Amp Type.
Pre Amp Middle
Pre Amp Treble
Pre Amp
Presence
0–127
(MATCH DRIVE:
-127 - 0)
Tone for the ultra-high frequency range
L in
R in
L out
R out
Pan R
Pan L
Pre Amp
Speaker
Pre Amp Bright OFF, ON
Turning this “On” produces a sharper
and brighter sound.
* This parameter applies to the “JC-
120,” “Clean Twin,” and “BG Lead”
Pre Amp Types.
Speaker Sw OFF, ON
Determines whether the signal passes
through the speaker (ON), or not
(OFF).
Speaker Type #4
(See the table be-
low.)
Type of speaker
Mic Setting 1, 2, 3
Adjusts the location of the mic that’s
capturing the sound of the speaker.
This can be adjusted in three steps,
from 1 to 3, with the mic becoming
more distant as the value increases.
Mic Level 0–127 Volume of the microphone
Direct Level 0–127 Volume of the direct sound
Pan L64–63R Stereo location of the output
Level 0–127 Output level
Parameter
Value Description
ARX-01_e.book 49 ページ ２００８年２月１９日 火曜日 午後４時７分