Roland F-110 Electronic Keyboard User Manual


 
22
Before You Play
The pedals perform the following operations. You’ll use them
mainly when playing piano.
fig.Pedals-e.eps_88
Damper Pedal (right pedal)
Use this pedal to sustain the sound.
While this pedal is held down, notes will be sustained for an
extended time even if you release your fingers from the
keyboard.
The length of the sustain will change subtly depending on
how deeply you press the pedal.
On an acoustic piano, holding down the damper pedal will
cause the strings for notes other than the ones you actually
play to vibrate in sympathy with what you’ve played,
producing a rich resonance. The F-110 simulates this
sympathetic vibration (damper resonance).
You can modify the sound of the sympathetic vibration.
Refer to p. 54.
Sostenuto Pedal (center pedal)
This pedal sustains only the notes of the keys that were
already pressed when you pressed the pedal.
Soft Pedal (left pedal)
This pedal is used to make the sound softer.
Playing with the soft pedal depressed produces a sound that
is not as strong as when otherwise played with the
equivalent strength. This is the same function as the left
pedal of an acoustic piano.
The softness of the tone can be varied subtly by the depth to
which you press the pedal.
You can switch the function of the sostenuto pedal and
the soft pedal. Refer to “Changing How the Pedals Work
(Center/Left Pedal Function)” (p. 51).
If you disconnect the pedal cable from the F-110 while
the power is turned on, the pedal effect will remain
applied. You must connect or disconnect the pedal
cable while the F-110’s power is switched off.
You can use headphones to enjoy the F-110 without
disturbing those around you, such as at night. Since the
F-110 has two headphone jacks, two people can also use
headphones simultaneously.
If you’re using only one set of headphones, you may connect
them to either of the two headphone jacks.
fig.Headphones-e.eps_88
1.
Plug the headphones into the headphones jack
located at the left of the F-110’s bottom panel.
If headphones are connected, no sound will be output from
the F-110’s speakers.
2.
Use the F-110’s [VOLUME] knob (p. 21) to adjust the
headphone volume.
About the Pedals
Soft Pedal
Sostenuto Pedal
Damper Pedal
Listening through Headphones
Headphones
F-110_r_e.book 22 ページ 2009年6月30日 火曜日 午後12時6分