Filter
Top Products
Editing a Live Set
64
2. Specify the write destination.
Select the write
destination for the
SuperNATURAL Synth
Tone.
3. Touch <WRITE>.
MEMO
• If you specify the same write destination for each of the
SuperNATURAL Synth Tones of layers 1–4, the message “Cannot
Write!” will appear. Specify dierent write destinations in step 2.
• If the same SuperNATURAL Synth Tone is assigned to layers
1–4, and you edit only the SuperNATURAL Synth Tone of a
certain layer and then perform this operation, the edited
SuperNATURAL Synth Tone will also be assigned to the other
layers as well.
Initializing a Live Set
Here’s how to initialize the currently selected Live Set.
MEMO
• Initializing the Live Set aects the data in the temporary area
(p. 16). When you initialize the Live Set, the temporary area for the
Tones will also be initialized.
• If you want to return the parameters of all sounds to their
factory-set state, use Factory Reset (p. 87).
1. In the Live set screen (p. 32), touch <UTILITY>.
The Live Set Initialize screen will appear.
2. Touch <Live Set Initialize>, and then touch <Select>.
A message will ask “Are you sure?”
3. Touch <OK>.