Filter
Top Products
128
Edit mode (EDIT)
• If you set [S1--S8], [R1--R8], or [P2] to NOTE ASSIGN, setting the controller to the
maximum position will transmit the specified velocity value. Setting the controller
to the minimum position will transmit a note message with a velocity of 0.
• If you assign this to [B1--B6] or [P1], the specified velocity value will be transmitted
when you turn the controller on. When you turn the controller off, a note message
with a velocity value of 0 will be transmitted.
Advanced mode
Advanced mode 1 of NOTE ASSIGN lets you specify the velocity value in addition to the items of
Basic mode.
1. Press the [EDIT] button.
2. Slightly move the controller to which you want to assign a Note message. In the case of
a button, press that button.
The display will indicate the number of the selected controller.
3. Verify that the display indicates the correct controller, and press the [ENTER] button.
4. Press the [NOTE] key and then press key [1].
The display will indicate “NT1.”
5. Press the [ENTER] button.
6. Input the channel.
7. Press the [ENTER] button.
8. Input the note number.
9. Press the [ENTER] button.
fig.v
The display will indicate “V--.”
*1 Reference
10.Input the velocity.
11.Press the [ENTER] button.
fig.p
The display will indicate “P--.”
*1 Reference
12.Specify the output port. (➔“Specifying the port” (p. 159))
13.If you are making an assignment for a button, specify the button mode.
(➔“Specifying the button mode” (p. 158))
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.