Filter
Top Products
30
Installing & Setting Up the Driver (Macintosh)
fig.3-13_40
9
Try playing the keyboard of the
PCR-30/50/80. If the number 2 or 3
in the diagram at right blinks, the
settings have been made correctly.
If a MIDI sound module is
connected to the PCR-30/50/80's
MIDI OUT connector, click the
MIDI connector icon shown in the
diagram at the right. If you hear
sound, the settings have been made
correctly.
10
Once again choose the MIDI menu command Check Connections to end
the test.
11
From the File menu, choose Quit to exit FreeMIDI Setup.
12
Make MIDI device settings on your sequencer software. For details on the
MIDI OUT/IN device to select, refer to “About the ports when using a USB
connection” (p. 159).
For details on port, refer to
“About the ports
when using a USB
connection” (p. 159).
For details on connecting a
MIDI sound module, refer
to the owner's manual for
your MIDI sound module.
For details on MIDI device
settings, refer to the
owner's manual for the
software you are using.
This completes the series of steps needed to connect the PCR-30/50/80 to the
Macintosh, install the MIDI driver, and make the driver settings.