Filter
Top Products
143
Edit mode (EDIT)
● Master Volume
F0 7F 7F 04 01 vL vM F7
Since a Master Volume message has a data range of 00 00–7F 7F and we do not need to specify the
range, we will use Basic mode. Since the two bytes of data are in the order of LSB and then MSB,
we will select “DT3” when we input the data.
1. Press the [EDIT] button.
The display will indicate “EDT”.
2. Slightly move the controller to which you want to assign the system exclusive message. In the
case of a button, press that button.
The display will indicate the number of the selected controller.
3. Confirm what’s indicated, and press the [ENTER] button.
4. Press the [SYSTEM Ex.] key.
The display will blink “SE0”.
5. Confirm what’s indicated, and press the [ENTER] button.
The display will indicate “F0,” which is the first byte (beginning status) of a system exclusive
message. (This cannot be changed.)
6. Confirm what’s indicated, and press the [ENTER] button.
7. Use the [7] and [F] keys to input the second byte “7F”.
8. Confirm what’s indicated, and press the [ENTER] button.
Input the third, fourth and fifth bytes in the same way.
9. Since the sixth byte is the data area, press the [DATA] key, and then press [3].
The display will indicate “DT3”.
10.Confirm what’s indicated, and press the [ENTER] button.
11.Since we selected “DT3” as the sixth byte, the seventh byte will automatically be
allocated as the data area and cannot be modified.
12.Confirm what’s indicated, and press the [ENTER] button.
13.Use the [F] and [7] keys to input the ending status byte “F7”.
14.Confirm what’s indicated, and press the [ENTER] button.
15.Specify the output port. (➔“Specifying the port” (p. 159))
16.If you are making an assignment for a button, specify the button mode.
(➔“Specifying the button mode” (p. 158))
The Master Volume message has now been assigned.