Filter
Top Products
138
Edit mode (EDIT)
■ RPN/NRPN ASSIGN
Here’s how you can assign an RPN or NRPN message to a controller.
fig.edt
1
Press the [EDIT] button.
The display will indicate “EDT”.
2
Slightly move the controller to which you want to assign an RPN or NRPN message. In the
case of a button, press that button.
fig.r-1
The display will indicate the number of the selected controller.
3
Confirm what’s indicated, and press the [ENTER] button.
4
Press the [RPN] key.
fig.rp0
The display will indicate “RP0”.
fig.np0
* If you want to assign an NRPN message, press the [NRPN] key. The following
procedure is the same as for RPN.
fig.c
5
Confirm what’s indicated, and press the [ENTER] button.
The display will blink “C--”.
*1 Reference
6
Input the channel. Use the [DEC][INC] buttons or the [0]–[F] keys to specify the channel.
7
Press the [ENTER] button.
fig.BANK-2
8
Use the [DEC][INC] buttons or the [0]–[F] keys to specify the RPN MSB
(CC#101) or NRPN MSB (CC#99).
*1 Reference
9
Press the [ENTER] button.
Mode Keyboard
Data entry MSB
(CC#6) range
Data entry LSB
(CC#38) range
Port
Basic mode 0 00–7FH Not transmitted PCR 1
Advanced mode 1 1 Assignable 00–7FH Assignable
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or
mode of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently
set value, or will blink if the value is different.