Filter
Top Products
136
Edit mode (EDIT)
Advance mode 1, 2
Advanced mode 1 of PROGRAM CHANGE ASSIGN lets you specify the upper and lower limits of the
program change value. Advanced mode 2 lets you transmit BANK LSB/MSB settings in addition to
the program change.
1. Press the [EDIT] button.
2. Slightly move the controller to which you want
to assign a Program Change message. In the
case of a button, press that button. The display
will indicate the number of the selected
controller.
3. Confirm what’s indicated, and press the
[ENTER] button.
Advanced mode 1
—Specifying the range of values
4. Press the [PROGRAM CHANGE] key and then
press key [1].
5. Press the [ENTER] button.
6. Input the channel.
7. Press the [ENTER] button.
8. The following display will appear.
fig.max
*1 Reference
9. Use the [DEC][INC] buttons or the [0]–[F] keys
to specify the upper value limit.
10.Press the [ENTER] button.
11.The following display will appear.
fig.min
*1 Reference
12.Use the [DEC][INC] buttons or the [0]–[F] keys
to specify the lower value limit.
13.Press the [ENTER] button.
Advanced mode 2
—Transmitting bank data
4. Press the [PROGRAM CHANGE] key and then
press key [2].
5. Press the [ENTER] button.
6. Input the channel.
7. Press the [ENTER] button.
8. Specify the bank select MSB (CC#00). Use the
[DEC][INC] buttons or the [0]–[F] keys to
specify the MSB.
fig.BANK-2
*1 Reference
9. Press the [ENTER] button.
10.Specify the bank select LSB (CC#32). Use the
[DEC][INC] buttons or the [0]–[F] keys to
specify the LSB.
fig.BANK-3
*1 Reference
11.Press the [ENTER] button.
12.Input the program change number.
13.Press the [ENTER] button.
14.The display will indicate “P--”.
fig.p1
*1 Reference
15.Specify the output port. (➔“Specifying the
port” (p. 159))
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or
mode of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently
set value, or will blink if the value is different.