Filter
Top Products
30
Chapter 2 Using the XV-5080 Effects
Performance Mode Settings
Three different Multi-effects can be used in a Performance.
Select which of these three Multi-effects to use with Part
Output MFX Select. With this parameter, the same Multi-
effects are applied to all selected Parts. You can adjust the
amount of effect to be applied to the Parts by adjusting their
Send Levels to each of the effect units. (Fig. 1)
The Send Level setting for each Tone can also influence effect
intensity (Fig. 2).
Furthermore, you can take the Multi-effects you have applied
to a Patch in a Part and apply them to the entire
Performance, or just part of the Performance.
fig.02-012.e
fig.02-013.e
The primary role of the effect settings is to determine the Part
Output Assign.
You can select from the following Part Output Assign
settings values to suit your purposes.
MFX: Selected when Multi-effects, chorus, and reverb are
used.
A-D: Selected when outputting in stereo without use of the
Multi-effects. Chorus and reverb can be used.
1-8: Selected when outputting in mono without Multi-
effects. Chorus and reverb can be used. When this setting is
used, chorus and reverb sounds are output in stereo
according to the Chorus Output Assign and Reverb Output
Assign settings.
PAT: The Part’s output destination is determined by the
settings of the Patch or Rhythm Set assigned to the Part.
The screen appears as shown below, according to the settings
values.
• For MFX
fig.02-014.e_70
• For A–D
fig.02-015.e_70
• For 1–8
fig.02-016.e_70
The following shows the basic setting procedure.
1. Select the Performance you wish to use.
2. Press [F5 (Effects)].
The Perform Effect page will appear.
3. Press [F1 (General)].
The General page will appear.
fig.02-017.e_70
4. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
the parameter you want to set.
5. Turn the VALUE dial, or press [INC]/[DEC] to select the
desired value.
* If you make a mistake when setting a parameter’s value, or you
don’t like the change you have made, just press [UNDO] to
restore the value the parameter originally had.
6. Repeat Steps 3 to 5 to set the Effect.
7. Press [EXIT] to return to the PERFORM Play page.
Performance
Part32
Chorus
Reverb
TONE
Multi-Effects
Patch
Part 1
Fig.1 – When Output Assign is set to “MFX” in the Performance
mode (the output settings for Tone are ignored)
Performance
Part32
Fig.2 – When Output Assign is set to “PATCH” in the Performance
mode (the output settings for Tone are valid)
TONE
Patch
Part 1
Chorus
Reverb
Multi-Effects