Filter
Top Products
77
Chapter 2 Using the XV-5080 Effects
Chap.2
Threshold (Reset Threshold)
Sets the volume level at which the reset begins.
Monitor (Reset Monitor)
Determines whether the sound used as the reset trigger is
output (ON) or not (OFF). This parameter is disabled when
Reset is set to OFF or Source.
Beat Change
Mode
Sets the manner in which the volume changes as one beat
progresses to the next.
LEGATO:The change in volume from one beat’s level to the
next remains unaltered. If the level of a following beat is the
same as the one preceding it, then there is no change in
volume.
SLASH:The level is momentarily set to 0 before progressing
to the level for the next beat. This change in volume occurs
even if the level of a following beat is the same as the one
preceding it.
Shuffle #
Sets the timing of volume changes in levels for even-
numbered Beats (Beat 1-2/Beat 1-4/Beat 2-2/...). The higher
the value selected, the later the timing with which the beat
progresses.
Output
Level (Output Level)
Adjust the output level.
59:ISOLATOR
An equalizer which cuts the volume greatly, allowing you to
add a special effect to the sound by cutting the volume in
varying ranges.
fig.2-69
Boost/Cut
Low (Level Low) #
Mid (Level Middle) #
High (Level High) #
These boost and cut each of the High, Middle, and Low
frequency ranges. At -60 dB, the sound becomes inaudible. 0
dB is equivalent to the input level of the sound.
Anti Phase Low
Switch (Anti Phase Low Switch)
This turns the Anti-Phase function on and off and sets the
level settings for the Low frequency ranges. When turned on,
the counter-channel of stereo sound is inverted and added to
the signal.
Level (Anti Phase Low Level)
Adjusting these levels for certain frequencies allows you to
lend emphasis to specific parts. (This is effective only for
stereo source.)
Anti Phase Mid
Switch (Anti Phase Middle Switch)
This turns the Anti-Phase function on and off and sets the
level settings for the Middle frequency ranges. When turned
on, the counter-channel of stereo sound is inverted and
added to the signal.
Level (Anti Phase Middle Level)
Adjusting these levels for certain frequencies allows you to
lend emphasis to specific parts. (This is effective only for
stereo source.)
Low Boost
Switch (Low Booster Switch)
Adjust whether Low Booster will be used (ON) or not (OFF).
This emphasizes the bottom to create a heavy bass sound.
Increasing this value gives you a heavier low end.
(Depending on the Isolator and filter settings this effect may
be hard to distinguish.)
Level (Low Booster Level)
Adjust the level.
Output
Level (Output Level)
Adjust the output level.
60:3D CHORUS
This applies a 3D effect to the chorus sound. The chorus
sound will be positioned 90 degrees left and 90 degrees right.
fig.2-70
L in
R in
L out
R out
Isolater
Low Boost
Low Boost
Isolater
L
R
3D Chorus
2-Band
EQ
2-Band
EQ
R out
L out