Filter
Top Products
72
Chapter 2 Using the XV-5080 Effects
Pan 1:2:3 (Output Pan 1:2:3)
Specify the stereo location of the pitch shift 1–3 sound. L64 is
far left, 0 is center, and 63R is far right.
Output
Level (Output Level)
Adjust the output level.
50:LOFI COMPRESS
This is an effect that intentionally degrades the sound
quality.
fig.2-60
Lo-Fi
Type (LoFi Type)
Lowers the audio quality. The audio quality will worsen as
this setting is increased.
Pre Filter
Type (Pre Filter Type)
Adjust the type of filter that will be applied before the sound
passes through the Lo-Fi effect.
Post Filter 1
Type (Post Filter 1 Type)
Adjust the type of filter that will be applied after the sound
passes through the Lo-Fi effect.
Post Filter 2
Type (Post Filter 2 Type)
OFF: A post filter 2 will not be used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Output
Level (Output Level)
Adjust the output level.
Pan (Output Pan)
Adjust the stereo location of the output sound. A setting of
L64 is far left, 0 is center, and 63R is far right.
51:LOFI NOISE
In addition to a Lo-Fi effect, this effect also generates various
types of noise, such as radio noise and disc noise.
fig.2-61
Lo-Fi
Type (LoFi Type)
Lowers the audio quality. The audio quality will worsen as
this setting is increased.
Post Filter
Type (Post Filter Type)
OFF:A filter will not be used.
LPF:The frequency region above the Cutoff Freq setting will
be cut.
Lo-Fi
2-Band
EQ
L in
R in
L out
R out
Pan R
Pan L
Lo-Fi
Radio
Noise Gen.
L in
R in
L out
R out
Pan R
Pan L
2-Band
EQ