Filter
Top Products
32
Controlling Logic RPC Pro
Selecting channels
1. Use CH ASSIGN to select the Logic RPC Pro mixer section that you want to
control.
The selected button will light.
[INPUT/INST]: Select this when you want to control INPUT.
If you want to control instruments, hold down [SHIFT] and press
[INPUT/INST].
[OUTPUT]: Select this when you want to control OUTPUT.
[BUS]: Select this when you want to control the buses.
[Tr 1–12]: Select this when you want to control TRACK 1–12.
[Tr 13–24]: Select this when you want to control TRACK 13–24.
2. Press [CH SELECT] to select the channel that you want to control.
[CH SELECT] of the selected channel will light.
For details on the Logic RPC
Pro mixer, refer to the column
“The structure of the Logic
RPC Pro mixer section”
(p. 32)
The structure of the Logic RPC Pro mixer section
The Logic RPC Pro mixer consists of the following five sections.
For each section you can change insert effect, bus send, pan, and volume settings.
■
Input section
This sends the inputs to the output section.
■
Instrument section
Software synthesizers are inserted here for use.
■
Output section
This mixes the sound of each channel and sends this mix to an output.
■
Track section
These are the tracks that record the input audio on the hard disk of the computer
and play it back. The playback audio is sent to the buses or outputs.
■
Bus section
This section allows effects to be inserted and used as send effects, or can be used
as a group mixer.
It is not possible to send audio
from the input section to the
track section. For details, refer to
“Overall signal flow” (p. 19).
You will need to purchase
software synthesizers separately.