Filter
Top Products
66
Using Effects
fig.04-25_30
12. Raise and lower the channel fader 16, and verify that the volume changes.
The Input Mixer channel fader is used to make fine adjustments to the
recording level. In order to record with optimal audio quality, the fader
should normally be set in the 0 dB position.
13. Press [TR 1-16 (MASTER EDIT)].
[TR 1-16 (MASTER EDIT)] indicator will light, channel fader will adjust
the Track Mixer channel level 1–16.
fig.04-26
14. Hold [REC] and press [TRACK STATUS] of
the track that you wish to record. For this
example, hold [REC] and Track Mixer
channel 1 [TRACK STATUS]. Track 1 will be recording track, and
[TRACK STATUS] indicator will blink red.
15. As described in “Recording On a Track (p. 36)” step 6–9, specify which
you wish to assign as the source. For this example, Input Mixer channel 16
is assigned to the recording track 1.
fig.QuickRouting
16. Begin the recording, following the
procedure described in “Recording
On a Track (p. 36)” step 11–14.
17. As described in “Playing Back the
Demo Performance (p. 28),” record
a performance and then listen to it.
TRACK STATUS / PHRASE PAD
9121
17
2
18
3
19
4
20
5
21
6
22
7
23
8
24
MASTER
(
dB
)
6
4
0
4
8
12
18
24
42
(
dB
)
6
4
0
4
8
12
18
24
42
TO
13 14 15 1610 11
FX 2FX1 FX 3 FX 4 FX 5 FX 6 FX 7 FX 8
AUX 2
AUX1
MST AUX 3 AUX 4 AUX 5 AUX 6 AUX 7 AUX 8
FX RTN
TR 17
-
24
TR 1
-
16
FADER
RTN
PHRASE
REC
PLAY
OFF
TRACK
MASTER
EDIT
V. FA DER
PAD
L
R
L
R
12
13
16
At this time, the sound of
input mixer channel 16 will
no longer be output
directly from master out,
and will be routed through
the track mixer.
1
+
AUTOMIX REC
REC
The remaining time for
recording is displayed in
the upper right of the home
condition screen.Consider
these numbers as
approximate values. In
addition to the remaining
time, the display can also
b
e switched to remaining
capacity (MB units,
percentage (%), or event
units).