Filter
Top Products
73
Add Finishing Touches to Your Project
Add Finishing Touches to
Your Project
5. Use TIME/VALUE dial to select
“On.” A dedicated mastering track
will appear.
6. Use [][][][] to
move the cursor to “STATUS.”
7. Use TIME/VALUE dial to select
“Rec.” Allowing you to mix down
to the mastering track.
fig.05-09_50
8. Use [][]
[][] to move the
cursor to “V.Track.”
9. Use TIME/VALUE dial
to select the V.Track of
Mastering track. For this
example, select “1.”
10. Use [][]
[][] to move the
cursor to “CDR Rec
Mode.”
11. If you want to make a
audio CD, use
TIME/VALUE dial to select “On.”
12. Use [][][][] to move the cursor to “After Rec.”
13. Specify the time location of the mastering track to which the mixdown will
be recorded. When creating an original audio CD, it is usually best to select
“to Zero.”
14. Use [][][][] to move the cursor to “Auto Marker.”
15. If this is turned “On,” a track number marker will automatically be
assigned to the beginning of the phrase that is mixed down. Normally you
will set this “On.”
For details on the signal
flow (routing) at this time,
refer to “Signal Flow
(Routing) (p. 75).”
SHUTTLE
MENU
AUTOMIX RECRESTART
STOP PLAY REC
PROJECT ENDROJECT TOP
EXT SYNC
TO THRU
FROM
PREVIEW
LOOPA
.
PUNCH TOOUTIN FROM
WAVE
DISP
REDO
UNDO
SHIFT
P
ROJECT TRACK EFFECT UTILITY
YES NO
ENTER EXIT
ZOOM
MIDI DISK
/
TIME / VALUE
/ /
SHUT / EJECT
+
+
1817
8,10,
12,14
7,9,11,
13,15
32
0
/-
56
1
4
987
P
REVIOUS NEXT
SCENE
AUX 7 AUX 8 USER
AUX 4 AUX 5 AUX 6
AUX 1 AUX 2 AUX 3
BANK
LOCATOR / MARKER / SCENE
Mastering Track is any
V.Track of the track 23/24.
Depending on the After
Rec (After Recording)
setting or on the location
relative to other markers,
the display may indicate
“Can’t Set Marker,” and the
track number marker may
not be assigned.
About After Rec parameter
to ZERO Place the data starting at 00h00m00s00f.
to last Phrs:0S Place the data after the end of the last phrase in the
mastering tracks.
to last Phrs:2S Place the data two seconds after the end of the last
phrase in the mastering tracks.
to last Phrs:4S Place the data four seconds after the end of the last
phrase in the mastering tracks.
Stay HERE Place the data at the time location at which it was actu-
ally recorded.