Filter
Top Products
Configuring the SDC 8200 system
86
As soon as the initialization of a conference console is accepted by the
central unit, the red signal light ring of the console goes off.
̈ Press the ENTER key to save this configuration.
Loading the factory-preset default configuration for the conference sys-
tem
If necessary, you can load the factory-preset default configuration for the
conference system.
Note!
Loading the factory-preset default configuration will delete all setting
of your current configuration! Your conference system then has to be
re-configured to become operational!
To load the factory-preset default configuration for the conference sys-
tem:
̈ From the central unit’s operating menu, choose “
Conference”,
“
Initialise Units” and “Load Defaults” one after the other.
The text “
Configuration will be overwritten. Continue?” is
shown on the display.
̈ Press the ENTER key to replace your current configuration by the fac-
tory-preset default configuration.
Adding a conference console to an already existing configuration
To add newly connected conference consoles to an already existing config-
uration:
̈ From the central unit’s operating menu, choose “
Conference”,
“
Initialise Units” and “Manual Init” one after the other.
The red signal light rings ¹ and the “Microphone active” LEDs ƹ on all
conference consoles start flashing.
̈ Choose “
Add Unit”.
Only the signal light rings of the conference consoles not yet initialized
remain flashing.
̈ Press the microphone key ƺ of the conference consoles which you
want to add to your configuration.
As soon as the initialization of a conference console is accepted by the
central unit, the signal light ring of the console goes off.
Removing a conference console from an already existing configuration
To remove a conference console from an already existing configuration:
̈ From the central unit’s operating menu, choose “
Conference”,
“
Initialise Units” and “Manual Init” one after the other.
The red signal light rings ¹ and the “Microphone active” LEDs ƹ on all
conference consoles start flashing.
̈ Choose “
Delete Unit”.
The text “
Mic. Number = 00” is shown on the display.
Initialise Units
3 Load Defaults
Initialise Units
1 Manual Init
Manual Init
2 Add Unit
Initialise Units
1 Manual Init
Manual Init
3 Delete Unit