Filter
Top Products
Getting Started
VX4380 256-Crosspoint Relay Matrix Module User Manual
1–9
Follow these steps to install the VX4380. If the module has Option 01, first refer
to the Option 01 User Manual for instructions on mounting the option.
CAUTION. The VX4380 Module is a piece of electronic equipment and therefore
has some susceptibility to electrostatic damage (ESD). ESD precautions must be
taken whenever the module is handled.
1. Record the revision level, serial number (located on the label on the shield of
the VX4380), and switch settings on the Installation Checklist.
2. Verify that the switches are set to the correct values. Refer to Configuration
for more information on setting switches.
3. Make sure that the mainframe power is off.
4. Insert the module into one of the instrument slots of the mainframe (see
Figure 1–5).
5. Cable Installation: Use the correct cable to interface between the module I/O
connector and the Unit Under Test (UUT). The recommended cable is listed
in Appendix A: Specifications.
Figure 1–5: Module Installation
Installation Procedure