Filter
Top Products
VX4380 256-Crosspoint Relay Matrix Module User Manual
4–1
Status and Events
The Status and Event Reporting System reports asynchronous events and errors
that occur in the VX4380 256-Crosspoint Relay Matrix Module. This system
consists of four 8-bit registers and two queues that you access through the
command language. You can use these registers and queues to query the
instrument status and control the interrupts that report events.
In general, after an interrupt occurs, first conduct a serial poll, query the registers
to see why the interrupt occurred, and then send the SYSTem:ERRor? query to
see a descriptive error message.
This section describes the four registers and two queues of the Status and Event
Reporting system. For each register, you are given a description, a table
describing all of the bits, and an example of how to use the register.
The Status and Event Reporting process, synchronizing programming com-
mands, and the system messages are also described in this section.
Status and Event Reporting System
The Status and Event Reporting system monitors and reports such events as an
error occurring or the availability of a response to a query. This system includes
descriptions of the following registers and queues:
H Status Byte Register
H Service Request Enable Register
H Standard Event Status Register
H Event Status Enable Register
H Output queue
H System Error and Event queue
The Status Byte Register, shown in Table 4–1, summarizes information from
other registers. Use a serial poll or a *STB? query to read the contents of the
Status Byte Register. The response is the sum of the decimal values for all bits
set. When you use a serial poll, bit 6 shows Request Service information. When
you use the *STB? query, bit 6, the Master Status Summary bit, indicates that
bits 5, 4, or 2 may be set.
Status Byte Register