Filter
Top Products
Using the input library
5
Track recording
51
AW1600 Owner’s Manual
7
If you want to adjust the effect, use the
[INPUT SEL] key to select the input chan-
nel. While you produce sound on your
instrument, adjust the [EQ] knob, [DYN]
knob, or [EFFECT 1]/[EFFECT 2] knobs of
the Selected Channel section.
Immediately after you select an input library, turning
the knobs of the Selected Channel section will control
the following items.
•Turning the [EQ] knob
...........Adjusts the amount of boost/cut for each
EQ band. To select the band that will be
adjusted, use the [HIGH] key, [HI-MID] key,
[LO-MID] key, or [LOW] key located at the
right.
•Turning the [DYN] knob
...........Simultaneously adjusts multiple dynamics
parameters to adjust the dynamics effect.
The result will depend on the library that
you selected.
•Turning the [EFFECT 1] knob
...........Adjusts the balance of direct sound and pro-
cessed sound for internal effect 1.
•Turning the [EFFECT 2] knob
...........Adjusts the balance of direct sound and pro-
cessed sound for internal effect 2.
8
In the same way, select input library set-
tings for the other input channels.
However, a maximum of two input channels can use
the internal effects at the same time.
Input library
Internal effect
EQ
Dynamics
Speaker
simulator
INPUT LEVEL
to the bus
MIC/LINE
INPUT jack
Input channel
• If the input channel is paired, the same settings will be applied to both channels.
NOTE
• Depending on the input library you select, the level of the
input channel may change. Re-adjust the volume balance
using the INPUT LEVEL knob in the INPUT SETTING popup
window.
NOTE
• If turning the [EQ] knob or [DYN] knob does not produce the
desired result, you can reload new settings from the EQ
library or dynamics library (
→
p. 77, 78).
HINT