Filter
Top Products
AW1600 Owner’s Manual
Convenient functions during mixdown/bounce operations
9
Mixdown and bounce operations
92
Here are some convenient functions that you can use during mixdown or bounce operations.
During mixdown, you can add signals from the input
channels or pad channels. For example, you could add a
performance from a workstation-type synthesizer (with
built-in sequencer) that is synchronized to the AW1600
song, or add sound effects that have been assigned to the
pads. To do this, perform the following steps after you
have completed “Preparing for mixdown” (→ p. 83).
1
In the Quick Navigate section, repeatedly
press the [RECORD] key or hold down the
[RECORD] key and use the CURSOR [ ]/
[] keys to access the MIXDOWN page of
the RECORD screen.
2
Press the [INPUT SEL] key or pad that cor-
responds to the input channel or pad chan-
nel you want to use, to add that channel as
a mixdown-source.
3
In the Selected Channel section, repeatedly
press the [PAN/BAL] knob or hold down the
[PAN/BAL] knob and use the CURSOR [ ]/
[] keys to access the PAN page of the PAN
screen.
4
Move the cursor to the PAN knob of the
channel you want to use, and turn the
[DATA/JOG] dial to adjust the pan setting.
5
In the Selected Channel section, repeatedly
press the [VIEW] key or hold down the
[VIEW] key and use the CURSOR [ ]/[ ]
keys to access the FADER page of the VIEW
screen.
In the FADER page of the VIEW screen, you can use
on-screen faders to adjust the faders (input level) of
each channel.
1 ON/OFF buttons
These buttons switch each channel on/off.
B Faders
These faders adjust the input level of each channel.
6
While you play back the song, move the
cursor to the on-screen faders and turn the
[DATA/JOG] dial to adjust the level of the
input channels/pad channels that you want
to use.
7
If necessary, adjust EQ, dynamics, and the
send level to the internal effects for each
input channel or pad channel.
Now you have completed the preparations for adding
input channel or pad channel signals to the mixdown.
Record the mixdown on the stereo channel as
described in “Recording on the stereo track” (→
p. 87).
Convenient functions during mixdown/bounce operations
Adding input signals or pad
performances during mixdown
• If the page you see is different than shown above, make sure
that input channels/pad channels are selected as the object
of your operations. (This is shown in the upper left of the
screen.) If track channels are selected, press one of the
[INPUT SEL] keys or pads.
NOTE
1
2