Filter
Top Products
15
Basics Section
Powering Up
Power-on Procedure
When you have made all the necessary connections
between your S03 and any other devices, make sure
that all volume settings are turned down all the way to
zero. Then turn on every device in your setup in the
order of MIDI masters (senders), MIDI slaves
(receivers), then the audio equipment (mixers,
amplifiers, speakers, etc.). This ensures smooth MIDI
operation and prevents speaker damage.
When powering down the setup, first turn down the
volume for each audio device, then switch off each
device in the reverse order (first audio devices, then
MIDI).
When using the S03 as MIDI slave:
Turning on the S03
In order to avoid possible damage to the speakers or other
connected electronic equipment, always switch on the
power of the S03 before switching on the power of the
amplified speakers or mixer and amplifier. Likewise,
always switch off the power of the S03 after switching off
the power of the amplified speakers or mixer and
amplifier.
Even when the switch is in the “STANDBY” position,
electricity is still flowing to the instrument at a minimum
level. When not using the S03 for an extended period of
time, be sure to unplug the AC power adaptor from the
wall AC outlet.
n Before you switch your S03 on or off, first turn down the
volume of any connected audio equipment.
1 Press the STANDBY/ON switch
2 A splash screen (“Welcome to S03”) is displayed
briefly.
3 The Multi or Voice Play Mode screen appears next.
4 Turn up the amplifier’s volume as necessary.
5 Adjust the S03’s [VOLUME] slider to set an
appropriate volume level.
MIDI master (transmitting device)
Audio equipment (first mixer, then amplifier)
12345678910111213141516LR
POWER
ON!!
S03 as MIDI slave (MIDI receiving device)
H
FOOT
CONTROLLER
OUTPUT
RLMONOON
STANDBY
DC IN PHONES
GrandPno
KEYELEMPAR T
OCTAVE
PAG E
XG001
VOLUME