Filter
Top Products
74
Voice Mode
6-1. VelLmt-L (Velocity Limit Low)
6-2. VelLmt-H (Velocity Limit High)
Set the minimum and maximum values of the velocity
range within which each Element will respond. Each
Element will only sound for notes played within its
specified velocity range.
❏
Settings: 1~127
7-1. NoteShift
7-2. Detune
These parameters determine the pitch of each Element.
❏
Settings: –63~0~+63
■ NoteShift
Set the amount (in semitones) by which the note
pitch is shifted.
■ Detune
Determines the fine tuning setting of the pitch.
8-1. PchSclSns
(Pitch Scale Sensitivity)
8-2. PchSclCN
(Pitch Scale Center Note)
You can set the Pitch Scaling for each Element. Pitch
Scaling controls the pitch according to the positions of
the notes on the keyboard.
■ PchSclSns
Adjust the sensitivity of the Pitch Scaling for each
Element according to the position of the note on the
keyboard. The “PchSclCN” parameter (below) is
used as the basic pitch for this parameter.
The higher the value, the lower the pitch becomes
when playing low notes, and the higher the pitch
becomes when playing high notes.
❏
Settings: 0%, 5%, 10%, 20%, 50%, 100% At +100%,
adjacent notes are pitched one semitone (100
cents) apart.
■ PchSclCN
Set the basic pitch used by the PchSclSns parameter
(above).
❏ Settings: C-2~G8
n You can also set this parameter by pressing the
respective note on the keyboard while holding down
the [ENTER] button.
VelLmt-L
KEYELEMPAR T
OCTAVE
PAG E
001
6 E 1
VelLmt-H
KEYELEMPAR T
OCTAVE
PAG E
127
6 E 1
NoteShift
KEYELEMPAR T
OCTAVE
PAG E
+00
7 E 1
Detune
KEYELEMPAR T
OCTAVE
PAG E
+00
7 E 1
PchSclSns
KEYELEMPAR T
OCTAVE
PAG E
100%
8 E 1
PchSclCN
KEYELEMPAR T
OCTAVE
PAG E
C3
8 E 1
Center(Basic Pitch)
Higher range
Lower range
Large
Small
–
+
Speed of
pitch change
Element Oscillator/Mixer/Element Pitch