Filter
Top Products
58
Multi Mode
15. VarConnect
(Variation Connection)
This determines how the Variation Effect is used in the
signal processing chain — as an Insertion effect or as a
System effect.
❏ Settings: INS (Insertion), SYS (System)
n The function of the Variation Effect changes depending
on this setting, as do the types of parameter changes.
n For more details on System and Insertion Effects, see
page 53.
16. Var Return (Variation Return)
Set the Return level of the Variation Effect.
❏ Settings: 0 ~ 127
n This can be set only when Variation Connection (above)
is set to “SYS.” When Variation Connection is set to
“INS,” “***” appears in the display and the setting
cannot be changed.
17. Var Pan (Variation Pan)
Set the stereo pan position of the Variation Effect.
❏ Settings: L63 (Left) ~ C (Center) ~ R63 (Right)
n You can also enter the settings below using the numeric
keypad.
1~63: L63~L01
64: C (Center)
65~127: R01~R63
n This can be set only when Variation Connection (above)
is set to “SYS.” When Variation Connection is set to
“INS,” “***” appears in the display and the setting
cannot be changed.
18. SndVar➞Rev
(Send Variation to Reverb)
Set the send level of the signal sent from the Variation
Effect to the Reverb Effect.
❏ Settings: 0~127
n This can be set only when Variation Connection (above)
is set to “SYS.” When Variation Connection is set to
“INS,” “***” appears in the display and the setting
cannot be changed.
19. SndVar➞Cho
(Send Variation to Chorus)
Set the send level of the signal sent from the Variation
Effect to the Chorus Effect.
❏ Settings: 0~127
n This can be set only when Variation Connection (above)
is set to “SYS.” When Variation Connection is set to
“INS,” “***” appears in the display and the setting
cannot be changed.
20. MW VarCtl
(MW Variation Effect Control Depth)
This determines the degree to which the Modulation
wheel controls the Variation Effect.
❏ Settings: –64~+63
n This can be set only when Variation Connection (above)
is set to “INS.” When Variation Connection is set to
“SYS,” “***” appears in the display and the setting
cannot be changed.
n The particular parameter that can be controlled with the
Modulation wheel is fixed for each of the Variation
effects. Refer to the separate Data List for details.
VarConnect
INS
KEYELEMPAR T
OCTAVE
PAG E
15
Var Return
064
KEYELEMPAR T
OCTAVE
PAG E
16
Var Pan
C
KEYELEMPAR T
OCTAVE
PAG E
17
SndVar Rev
000
KEYELEMPAR T
OCTAVE
PAG E
18
SndVar Cho
000
KEYELEMPAR T
OCTAVE
PAG E
19
MW VarCtl
+00
KEYELEMPAR T
OCTAVE
PAG E
20
Common Effect