Yamaha S03 Musical Instrument User Manual


 
41
Basics Section
Splitting the Keyboard —
Setting Upper and Lower
Ranges for the Voices
The illustration below shows an example in which the
keyboard has been effectively divided into two spearate
key ranges, letting you play one Voice over one range,
and a second Voice over the other. In the following
example, the Voices change at the note C3, letting you
play a string Voice in the lower range and a piano Voice
in the upper. To set up the Voices in this way, follow
the instructions below.
1 Press the [MULTI] button, followed by the [EDIT]
button (each LED will light) to enter the Multi Edit
mode.
n You need to select the Multi before entering the Multi
Edit mode (page 37).
2 If the Common Edit screen is shown, press the [+]
or [–] button to select the Part Edit display.
3 Select a Part for the lower range by using the PART
[+] and [–] buttons. For this example, select “P1
(Part 1).”
4 Use the [] and [] buttons (if necessary) and call
up the Voice Selection screen (PAGE 1) to select a
strings Voice for the lower range Part.
n For details about Voice selection, see page 59.
5 Use the [] and [] buttons to call up the Volume
screen (PAGE 2), then set the volume for the piano
Part as well as its Pan position, Chorus and Reverb
Send levels, if necessary. For details, see page 56.
6 Use the [] and [] buttons to call up the NtLmt
screen (PAGE 4), and specify a key range for the
lower and upper Parts. Switch between the NtLmt-
L (Note Limit Low) and NtLmt-H (Note Limit
High) screens by pressing the [E] and [F]
buttons. Select “C-2” for the lowest note and “B2”
for the highest.
7 Use the [] and [] buttons to call up the Rcv Ch
(MIDI Receive Channel) screen (PAGE 6). Select
“1” for “RcvCh.”
n Set the MIDI Transmit Channel to 1 from the Trans
Ch display (PAGE 4 ) in the MIDI mode. Now you
are ready to play the Part 1 Voice within the lower
range. The Voice assigned to Part 1 can be played
over MIDI Receive Channel 1.
8 Use the [] and [] buttons to call up the Mono/
Poly screen (PAGE 8). Set the parameter to “poly”
(polyphonic).
(C3)
UpperLower
Part 2
Piano
Ch1
Part 1
Strings
Ch1
KEYELEMPAR T
OCTAVE
PAG E
Strings1
XG049
KEYELEMPAR T
OCTAVE
PAG E
4 P
KEYELEMPAR T
OCTAVE
PAG E
4 P
NtLmt-L
C-2
NtLmt-H
B2