Emergency repairs
– 99 –
Side Marker Lights
NOTE: Marker light is a sealed
assembly and must be
replaced as a unit; the bulb
alone cannot be replaced.
1. Remove two torx head screws (1).
2. From behind side marker light
assembly, clip tie wraps.
3. Pull assembly out and carefully
remove the two inline connections
(2) by pulling them apart.
4. Remove the sheet metal nut and
carefully pry marker light off adhe-
sive-backed foam.
5. If necessary, replace adhesive-
backed foam pad.
6. Replace marker light.
7. Replace tie wraps.
Side Lights
1. Find the tab on the yellow lens.
Using a narrow blunt tool, such as
a flat screwdriver, pry off the lens
using a gentle twisting motion.
2. Change bulb.
3. Replace lens.
Rear Lights
1. Locate the two tabs at the bottom
of the housing. Pop open (down).
2. Lift outer cover and remove sealed
lamp and install new one.
3. Lower cover and snap tabs back in
place.
Turn signal, front
1. Remove the two screws and then
detach the turn signal light assem-
bly.
2. Release the protective rubber
cover from the bulb holder.
3. Rotate the bulb holder counter-
clockwise and detach from the turn
signal lamp assembly.
4. Lightly depress and then remove
the bulb from the bulb holder.
PB1340A.book Page 99 Friday, September 1, 2000 7:40 AM
