Consumer Information and Vehicle Identification Vehicle Identification
– 109 –
Complete Vehicle
Certification Label
The Complete Vehicle Certification
label certifies that the vehicle complies
with all applicable Federal Motor Vehi-
cle Safety Standards. It is located on
the driver’s side door frame and con-
tains the following information:
• Date of manufacture.
• GVWR — Gross Vehicle Weight
Rating.
• GAWR FRONT and REAR —
Gross Axle Weight Ratings for
Front and Rear Axle.
• TIRE/RIM SIZES AND INFLATION
PRESSURES — Tire/Rim Sizes
and Cold Pressure Minimums.
• VIN — Vehicle Identification Num-
ber.
Incomplete Vehicle
Certification Label
The Incomplete Vehicle Certification
Label (for trucks) is located on the
driver’s door frame. It contains the fol-
lowing information:
• DATE OF MANUFACTURE.
• VIN — Vehicle Identification Num-
ber.
• LISTING OF APPLICABLE FED-
ERAL MOTOR VEHICLE SAFETY
STANDARDS.
Tire and Rim Information
Label
The Tire and Rim Information Label (for
trucks) is located on the driver’s door
frame. It contains the following informa-
tion:
• GVWR — Gross Vehicle Weight
Rating.
• GAWR FRONT and REAR —
Gross Axle Weight Ratings for
Front and Rear Axle.
• TIRE/RIM SIZES AND INFLATION
PRESSURES — Tire/Rim Sizes
and Cold Pressure Minimums.
• Chassis No.
WARNING! Do not exceed
the specified load rating.
Overloading can result in
loss of vehicle control and
personal injury, either by
causing component failures
or by affecting vehicle han-
dling. Exceeding load rat-
ings can also shorten the
service life of the vehicle.
PB1340A.book Page 109 Friday, September 1, 2000 7:40 AM
