General Periodical maintenance
– 86 –
Table 4 Recommended Lubrication Types
COMPONENTS RECOMMENDED LUBRICANT
Power Steering Gear Chevron Torque Fluid C4, Dexron III, or Mercon
Driveline U-Joints
Slip-Joint Splines
Cab Pivots
Clutch Pedal Shaft
Other chassis grease fittings not covered
below.
EP chassis grease, lithium 12-hydroxystearate or lithium complex base, NLGI 2.
Wheel Bearing-Non Driving Axles OIL LUBRICATED: SAE 75W-90 synthetic oil
Threaded Pins & Bushings (e.g., spring pins &
bushings)
EP grease, lithium 12-hydroxystearate or lithium complex base, NLGI 2, with 3% molybdenum
additive: Mobil Grease Special (Mobil), Molygrease EP (Chevron), or equal.
Suspension Fittings (other than threaded pins
& bushings)
EP chassis grease, lithium 12-hydroxystearate or lithium complex base, NLGI 2.
Steering Axle: Grease Fittings on Steering
Arm; Tie Rod Ends; Drag Link; King Pins
EP chassis grease, lithium 12-hydroxystearate base, NLGI 2.
Clutch Release Bearing (remove inspection
plate for access); Driveshaft Center Bearing
High temperature ball bearing grease. Chevron SRI Mobil Grease HP, Texaco Multifax 2, or
equivalent.
Automatic Slack Adjusters; Wedge Brake
Components; Disc Brake Caliper
High temperature EP grease; Texaco Thermotex EP-1, Shell Darina EP-1, Mobilith AW-1,
Rockwell 0-616A, or equivalent.
Cam Brake Camshaft Splines; Disc Brake
Shaft Splines and Slide Pin Retainers; Brake
Clevis Pins
Antiseize type grease, Rockwell specification 0-637.
Deviations from the above list of lubricants should be based on specifications published in the component manufacturer’s manuals or otherwise
approved by the manufacturer.
PB1340A.book Page 86 Friday, September 1, 2000 7:40 AM
