Chassis Getting to Know Your Vehicle
– 46 –
Multi-function Switch, Right
Windshield wipers
Position A:
wipers off.
Position B:
wipers on, normal speed.
Position C:
wipers on, high speed.
Position D:
single wipe and intermittent
wipe function
Momentarily depress the switch (up to
½ sec.) and then release to obtain a
single wipe of the windshield. Depress
the switch for between ½ to 1½ secs to
activate the intermittent wipe function;
depress the switch for ½ to 1½ secs to
cancel the intermittent wipe mode.
NOTE: A single wipe can be
carried out between intermit-
tent wipes without cancelling
the intermittent wipe cycle.
The windshield wipers work only with
the ignition switched on.
Windshield washers
The windshield washers are activated
by depressing button (E) against spring
pressure.
The wipers simultaneously make three
sweeps across the windshield.
Chassis
Towing Pin
The front bumper incorporates a towing
pin which can be fitted to the left or right
side of the bumper and is suitable for all
normal towing. Refer to the “
Emer-
gency Repairs
” section of this hand-
book for the recommended towing
procedures.
PB1340A.book Page 46 Friday, September 1, 2000 7:40 AM
