General Periodical maintenance
– 78 –
Drain Water from Fuel System I Per Engine Manufacturer Requirements
Engine Oil – Change
Per Engine Manufacturer Requirements
Oil Filters – Replace
Per Engine Manufacturer Requirements
Fuel Filters – Replace
R
Cranking System:
Visual Inspect./Loose Connections I
Alternator/Charging System:
Visual Inspection/Loose Connections I
UNDER VEHICLE A B C D
Steering Components – Condition: I
Steering Gear
I
Steering Shaft Splines and Joint(s) I
Pitman Arm
I
Drag Link
I
Steering Arms
I
Tie Rod Arms
I
Tie Rod Ends
I
Radius Rods / Torque Arms
I
Chassis Frame – Cracks or Breaks
I
Spring Shackles and Hanger Brackets
I Check For Cracks Check Fastener Torque
Spring Pins I
King Pin Wear I Per Manufacturer’s Specification
Steer Axle Wheel Bearing End Play Inspection
I
With LMS Outer Ends 350,000 Miles
• No Leak – No Service
Front Hub Lubricant Level I
Spring Leaves
I
U–Bolt and Suspension Fastener Torque
I
Tighten U-bolts after the first 500 miles (800 km). Rear suspension fas-
teners: retorque after first 2,000 miles (3218 km).
Table 2 Maintenance Schedule
PB1340A.book Page 78 Friday, September 1, 2000 7:40 AM