Filter
Top Products
60 ARTURIA – MOOG MODULAR V 2.6 – USER’S MANUAL
parameter_value = MIN + (MAX – MIN) * control_value
6.3.5.5 Multiple assigned parameters
It is possible to assign multiple parameters to a single control. This allows you to change many
parameters with one fader or knob.
Activate “Learn” mode, select a parameter (GUI control)
Tweak control to assign it (optionally setup minimum and maximum)
Select a second parameter
And tweak the same control
Deactivate “Learn” mode
Tweaking assigned control should modify both parameters with regards to assignation setup
(Min, Max).
6.3.5.6 Tricks
The Oscillator 1 to 9 tune controls have two parameters: FINE and COARSE tune. If
“Learn” mode is ON, clicking on control provides access to the assignation of the FINE
parameter, shift+clicking on control provides access to assignation of the COARSE
parameter.
Input
control
values
MAX
MIN
POSITIVE SLOPE
Output
parameter
values
Inp
ut
control
values
MAX
MIN
NEGATIVE SLOPE
Output
parameter
values
Input
control
values
MAX
MIN
DEFAULT
Output
parameter
values